ESPRIT 642BL Uživatelský manuál stáhnout pdf (Strana 11)

Esprit+ (642BL) 9

[3] Keypad Code

Use this option to change the Keypad Code (default: 0000). After

entering Keypad Programming Mode, select section [3]. Enter the

new four-digit keypad code. During the keypad’s power up, the

display reads: for keypad reset enter and clear.

To set the keypad code to default, press and hold the [

ENTER] key.

Without releasing the [

ENTER] key, press and hold the [CLEAR] key.

Hold both keys until the display shows the system status.

[4] Read Key

Use this option to copy the programmed options and labels

(messages) from a Paradox Memory Key to the keypad’s memory.

Insert a programmed Paradox Memory Key into the keypad

connector labelled “key” (see Figure 1 on page 29). After entering

Keypad Programming Mode, select section [4] and then press the

[

ENTER] key. The display reads: Reading Key. The keypad will

copy the contents from the key into keypad memory. This may take

approximately 15 seconds. Once the information has been copied,

the keypad will emit a confirmation beep.

[5] Write Key

Use this option to copy the programmed options and labels

(messages) from a keypad to a Paradox Memory Key. Insert the

Paradox Memory Key into the keypad connector labelled “key” (see

Figure 1 on page 29). Make sure the Memory Key’s jumper is on.

After entering Keypad Programming Mode, select section [5] and

then press [

ENTER]. The display will read: Writing Key. This may

take approximately 15 seconds. When the process is complete, the

keypad will emit a confirmation beep. Program one keypad, copy its

contents to the memory key as explained in this option, then program

as many keypads as required using option [4] (see above).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Žádné komentáře

ESPRIT 642BL Uživatelský manuál Strana 11